|
||||||||
1. Remove the Brake caliper and bracket, be sure to support
the caliper. |
||||||||
|
4. Remove the four flange bolts.
Caution: Do not allow the legs to enter the threaded bolt holes or the open slots in the rotor. The remover legs must be on the flat surface. 7. Install four lug nuts onto the wheel studs protruding through the bottom of the remover plate. Tighten securely. 8. Rotate the puller lift bolt clockwise until the puller is tight, centered, and in alignment. Tap the puller lift bolt to help center the puller.
The puller lift bolt threads must be lubricated to reduce stress, friction & binding.
|
|||||||