|
|
 |
Caution: Do not continue to tighten the puller if it is not centered, aligned and the legs are not on the flat surface of the rotor flange.
|
|||||||
|
|
9. Rotate the puller lift bolt until the hub is backed out of the bearing. Be careful, do not drop the hub or the rotor when the hub backs out of the bearings. Lubricate the wheel bearing seal. Lubricate the bearing race on the hub. Push the hub onto the drive shaft and into the inner bearing. Install the drive shaft nut and tighten. Rotate the rotor as the drive shaft nut is tighten. Torque the four bolts and the drive shaft nut to specifications.
|
|||||||
|
|
|
|||||||
 |
||||||||
